24 x 32 LED WRITING BOARD menu Flashing Fluorescent sign neon 8 pens message

Led Signs 7" x 51" Full Color 10MM PITCH PROGRAMMABLE NEON DIGITAL MESSAGE BOARD

$432.24
End Date: Wednesday Aug-21-2019 14:39:06 PDT
Buy It Now for only: $432.24
Buy It Now | Add to watch list

LED Sign P5 Programmable scrolling message Board Multi-color 8Inch x 40inch
$289.00
End Date: Friday Sep-13-2019 2:09:35 PDT
Buy It Now for only: $289.00
Buy It Now | Add to watch list

PRISMVIEW LLC ELECTRONIC MESSAGE DISPLAY BOARD FOR WET LOCATIONS BY7DVIX16
$49.99
End Date: Wednesday Sep-11-2019 16:50:38 PDT
Buy It Now for only: $49.99
Buy It Now | Add to watch list

Making A Flashing Led Circuit Message Board

Recent trend for the advertisement of Entertainment industry has substantiated in its own uniqueness of hand-written messages. This allows the advertisers to freely write, draw, anything they want at different occasions. The hand-written LED message board is widely used to cope with various needs with creativities.

LED lights have a variety of uses. You can use them as a distress signal during an emergency, at a party to spruce up an event, or by using smaller bulbs you can even decorate a greeting card. However you choose to use the Flashing LED Board it is sure to catch someone’s attention.

Step 1: First, you will need a flashing LED bulb. These can be found at a hardware or electronics store. Choose one that can be hooked to a 9-volt battery system.

Step 2: The next step is to attach the bulb. Connect the longer lead of the LED to the positive end of the battery. Connect the shorter lead of the LED to the negative end of the battery.

Step 3: You should also have the circuit board ready. Using pliers, insert the leads connected to the battery to the circuit board plug. At this point you should see the bulb flashing

Step 4: Now make the connection permanent. Using about 4 inches of 20-gauge wire, remove about half an inch of copper conductor at the ends of the wire. Prepare your soldering iron. Once it is ready, solder the red wire to the switch. Let it cool down before you switch it on.

Step 5: Once the soldered part has cooled down, you can attach the positive lead, attached to the positive end of the battery, to the switch. Connect the negative lead, negative end of battery and the negative lead of the battery. Now you can test the connection by switching it on. The LED bulb you have installed should flash.

Step 6: You can add more bulbs to the circuit if you need. Just follow the same procedures stated above.

Most LED message board have a 200, 000 hour service time and are completely maintenance free. It is easy to clean, does not heat up, operates silently and it is safe to touch. Another advantage of the LED Signs fluorescent boards is that they are break and scratch resistant even after prolonged or continuous writing and usage.

LED message boards with neon effect is flamboyant, glamorous and an absolute catcher of eyeballs.

Lari Smith has been writing articles online for nearly 3 years now. Specialize in business signs articles. If you need more about Advertising signs and LED Message Board method, please reference http://www.flashingboards.com/.